Dump Tubes

Dump Tubes are an important part of a system discharging in a condenser. These devices are primarily deployed to minimize the size of the bypass valve outlet where the specific volume of steam dramatically increases at low or sub-atmospheric pressures.

These dump tubes are normally fitted into the condenser inlet duct and are carefully designed to achieve the final pressure reduction stage and allow the steam to expand and cool prior to entering the turbine exhaust or condenser.

It is recommended to ensure that the dump tube is designed properly with respect to size, shape and profile so as to avoid interference with the turbine exhaust steam path under normal turbine operation. The arrangement and the size of the holes in the dump tube are selected so as to minimize noise generation and direct the steam path away from the duct walls and towards the condenser inlet depending upon the installation.

Depending upon the installation, the arrangement of the holes are selected. In case the dump tube is installed in the condenser then the arrangement of the holes is such that the holes are drilled in two 90-degree sectors.

This does not allow the steam to go up the turbine exhaust or directly down on to the tubes in the condenser. In case the dump tube is installed in the turbine exhaust then the holes are drilled around the complete circumference i.e. 360 degrees. The dump tubes are made in single and for special applications double tube versions are available. The material varies as per requirement from alloy steel, carbon steel or stainless steel.

Dump tubes are combined with a Steam conditioning valve or Turbine bypass valve for dumping the steam in the Condenser.

These tubes are deployed to reduce the bypass valve size and thereby reduce the overall cost of the system.

By installing dump tubes large pipe sizes between the Bypass valve and the Condenser are reduced and made very short.

Each dump tube is a tailor-made device for each application.